EIGENROOM / LECTURE ROOM / TEXTBOOK MAP

Find your textbook chapter.

Studying with Ogata, Nise or Franklin? Pick the chapter your course is on and open the matching lectures and experiments. Every lecture has a worked example, and lectures with practice problems include full solutions.

OGATA

K. Ogata, Modern Control Engineering, 5th ed.

Used in many Korean and international first courses. Chapters 2–4 are modeling, 5–8 classical analysis and design, 9–10 state space.

Ch. 1Introduction to control systems
Ch. 3Mechanical and electrical systems
02From hardware to equations06RLC dynamics and electrical resonance15Read a step response

Not covered here yetGear trains, op-amp circuits and two-mass systems.

Ch. 4Fluid and thermal systems
05Tank balance and local linear models33Thermostats, PI and heating limits

Not covered here yetInteracting tanks, pneumatic and hydraulic systems.

NISE

N. S. Nise, Control Systems Engineering

Separates analysis chapters from design chapters: root locus (8) then design via root locus (9), frequency response (10) then design (11).

FRANKLIN

G. F. Franklin, J. D. Powell, A. Emami-Naeini, Feedback Control of Dynamic Systems

Introduces PID and steady-state error early (ch. 4), then one chapter each for root-locus, frequency-response and state-space design.

Ch. 1An overview and brief history of feedback control
Ch. 9Nonlinear systems
04A useful model near one operating point05Tank balance and local linear models

Not covered here yetDescribing functions and Lyapunov stability.

BEYOND THE FIRST COURSE

Lectures that go past an introductory textbook

Chapter numbers refer to each book's table of contents so you can find the matching topic. EIGENROOM is independent of the authors and publishers and reproduces no textbook problems or figures.