EIGENROOMLAB WORKSHEET 11Cart-pole · Cart balance

Balance is not position

NameSectionDate

Goal

Show that keeping the pole upright does not keep the cart in place, and measure what the outer position loop costs.

Setup

Open it on a phone or a computer; there is nothing to log in to or install. The link loads run A's settings:

Initial angle
6°
Controller type
PID
Position loop
Angle only
Proportional Kp
15
Integral Ki
0
Derivative Kd
3
Sensor noise
0
Disturbance events
Nudge cart 1.2 N·s at 1.4 s
Recording
8 s
  1. APreset, exactly as the link opens it.
  2. BChange only: Position loop → Balance + position.

Pin each run before you change a setting, so you can compare runs at the same replay time.

1. Predict

Can the pole stay upright while the cart drifts away?

Write your prediction and a reason before you run anything.

2. Observe

Read each value in the lab and write it in the table.

QuantityWhere to read itAB
Recording ends at (s)Replay slider and status
Peak angle (°)Measured response
Peak cart travel (m)Measured response
Final cart position (m)Measured response

3. Explain

  1. Run A never lets the pole fall, yet its recording stops early. What ended it?

  2. The cascade run tilts the pole further than angle-only control did. Why is a larger lean part of bringing the cart home?

Extension (optional)

Double the nudge in cascade mode (run C). Does the cart stay on its track?

Source: eigenroom.com/worksheets/cart/positionCite: EIGENROOM. (2026). Balance is not position [Lab worksheet]. Accessed YYYY-MM-DD. https://eigenroom.com/worksheets/cart/position