EIGENROOMLAB WORKSHEET 01DC motor · Feedback basics

Find the feedback loop

NameSectionDate

Goal

Read a feedback loop in numbers: how fast the motor reaches its target, how far it overshoots and how much voltage it needs to stay there.

Setup

Open it on a phone or a computer; there is nothing to log in to or install. The link loads run A's settings:

Target speed
120 rad/s
Loop
Closed loop
Controller type
PID
Proportional Kp
0.22
Integral Ki
0.6
Derivative Kd
0.008
Anti-windup
On
Load torque
0.04 N·m
Sensor noise
0
Controller period
20 ms
Disturbance events
None
Recording
12 s
  1. APreset, exactly as the link opens it.
  2. BChange only: Target speed → 80 rad/s.

Pin each run before you change a setting, so you can compare runs at the same replay time.

1. Predict

Where does the motor speed go after you change the target?

Write your prediction and a reason before you run anything.

2. Observe

Read each value in the lab and write it in the table.

QuantityWhere to read itAB
Rise time, 10–90% of target (s)Measured response
Overshoot vs target (%)Measured response
Settling, ±2% of target (s)Measured response
Final error (rad/s)Measured response
Requested voltage at t = 0 s (V)Readout at 0 s
Applied voltage at t = 12 s (V)Readout at 12 s

3. Explain

  1. Both runs end with zero error, yet the applied voltage at 12 s differs. Why does run A need more voltage than run B to stay at its target?

  2. If the loop were linear, the overshoot in percent would not depend on the target. Compare the two overshoots. What does the requested voltage at t = 0 s tell you about why they differ?

Extension (optional)

Lower the target until the request at t = 0 s stays within 12 V: try 50 rad/s, then 25 rad/s. Does the percentage overshoot now stay the same when you halve the target?

Source: eigenroom.com/worksheets/motor/feedbackCite: EIGENROOM. (2026). Find the feedback loop [Lab worksheet]. Accessed YYYY-MM-DD. https://eigenroom.com/worksheets/motor/feedback