EIGENROOMLAB WORKSHEET 16DC motor · Design challenges

A good margin, a bad run

NameSectionDate

Goal

Show that a phase margin describes the small-signal loop and cannot certify a saturated run.

Setup

Open it on a phone or a computer; there is nothing to log in to or install. The link loads run A's settings:

Target speed
120 rad/s
Loop
Closed loop
Controller type
PID
Proportional Kp
0.4
Integral Ki
0.6
Derivative Kd
0.008
Anti-windup
Off
Load torque
0.04 N·m
Sensor noise
0
Controller period
20 ms
Disturbance events
None
Recording
12 s
  1. APreset, exactly as the link opens it.
  2. BChange only: Target speed → 20 rad/s.

Pin each run before you change a setting, so you can compare runs at the same replay time.

1. Predict

Why can the frequency plot look acceptable while the motor overshoots?

Write your prediction and a reason before you run anything.

2. Observe

Read each value in the lab and write it in the table.

QuantityWhere to read itAB
Phase margin (°)Frequency workbench
Requested voltage at t = 0 s (V)Readout at 0 s
Overshoot vs target (%)Measured response
Settling, ±2% of target (s)Measured response

3. Explain

  1. The phase margin is the same in both runs. Why?

  2. Use the requested voltage at t = 0 s to explain why run A overshoots so much more than run B.

Extension (optional)

Try targets of 30 rad/s and 40 rad/s. Where does the request at t = 0 s first exceed 12 V, and what happens to the overshoot?

Source: eigenroom.com/worksheets/motor/margin-versus-saturationCite: EIGENROOM. (2026). A good margin, a bad run [Lab worksheet]. Accessed YYYY-MM-DD. https://eigenroom.com/worksheets/motor/margin-versus-saturation