EIGENROOMLAB WORKSHEET 19DC motor · Design challenges

Design model versus actual motor

NameSectionDate

Goal

Measure how a controller tuned for the nominal motor behaves when the real inertia or friction differs.

Setup

Open it on a phone or a computer; there is nothing to log in to or install. The link loads run A's settings:

Target speed
95 rad/s
Loop
Closed loop
Controller type
PID
Proportional Kp
0.22
Integral Ki
0.6
Derivative Kd
0.008
Anti-windup
On
Load torque
0.04 N·m
Sensor noise
0
Controller period
20 ms
Actual inertia
1×
Actual friction
1×
Disturbance events
None
Recording
12 s
  1. APreset, exactly as the link opens it.
  2. BChange only: Actual inertia → 2×.
  3. CChange only: Actual friction → 2×.

Pin each run before you change a setting, so you can compare runs at the same replay time.

1. Predict

Will a controller tuned for the nominal motor behave the same if inertia doubles?

Write your prediction and a reason before you run anything.

2. Observe

Read each value in the lab and write it in the table.

QuantityWhere to read itABC
Rise time, 10–90% of target (s)Measured response
Overshoot vs target (%)Measured response
Settling, ±2% of target (s)Measured response
Control effort (V·s)Measured response
Phase margin (°)Frequency workbench

3. Explain

  1. Doubling the actual inertia: what happens to rise and settling time, and what does the frequency workbench report?

  2. Doubling friction instead reduced the overshoot. Does that make the controller robust? What would you test before claiming it?

Extension (optional)

Try an actual inertia of 0.5×. Does a mismatch always make the response worse?

Source: eigenroom.com/worksheets/motor/model-mismatchCite: EIGENROOM. (2026). Design model versus actual motor [Lab worksheet]. Accessed YYYY-MM-DD. https://eigenroom.com/worksheets/motor/model-mismatch