EIGENROOMLAB WORKSHEET 03DC motor · PID tuning

What does P change?

NameSectionDate

Goal

Measure what a larger proportional gain buys and what it costs when the controller has no integral action.

Setup

Open it on a phone or a computer; there is nothing to log in to or install. The link loads run A's settings:

Target speed
120 rad/s
Loop
Closed loop
Controller type
PID
Proportional Kp
0.16
Integral Ki
0
Derivative Kd
0
Anti-windup
On
Load torque
0.04 N·m
Sensor noise
0
Controller period
20 ms
Disturbance events
None
Recording
12 s
  1. APreset, exactly as the link opens it.
  2. BChange only: Proportional Kp → 0.24.

Pin each run before you change a setting, so you can compare runs at the same replay time.

1. Predict

Will a higher P gain reach the target faster without a cost?

Write your prediction and a reason before you run anything.

2. Observe

Read each value in the lab and write it in the table.

QuantityWhere to read itAB
Requested voltage at t = 0 s (V)Readout at 0 s
Speed at t = 12 s (rad/s)Readout at 12 s
Final error (rad/s)Measured response
Control effort (V·s)Measured response

3. Explain

  1. Neither run reaches the target. Why does a P-only controller settle below it, and why is the gap smaller in run B?

  2. Compare the requested voltage at t = 0 s with the 12 V the motor can receive. What does the larger gain cost that the speed plot does not show?

Extension (optional)

How large must Kp be to bring the final error below a tenth of the target? Try Kp = 1 and watch the voltage as well as the speed.

Source: eigenroom.com/worksheets/motor/proportionalCite: EIGENROOM. (2026). What does P change? [Lab worksheet]. Accessed YYYY-MM-DD. https://eigenroom.com/worksheets/motor/proportional