EIGENROOMLAB WORKSHEET 06DC motor · PID tuning

When the actuator runs out

NameSectionDate

Goal

See integrator windup in the requested voltage and measure how much anti-windup changes the recovery.

Setup

Open it on a phone or a computer; there is nothing to log in to or install. The link loads run A's settings:

Target speed
140 rad/s
Loop
Closed loop
Controller type
PID
Proportional Kp
0.22
Integral Ki
1.2
Derivative Kd
0.008
Anti-windup
On
Load torque
0.04 N·m
Sensor noise
0
Controller period
20 ms
Disturbance events
None
Recording
12 s
  1. APreset, exactly as the link opens it.
  2. BChange only: Anti-windup → Off.

Pin each run before you change a setting, so you can compare runs at the same replay time.

1. Predict

What happens when the requested voltage exceeds what the motor can receive?

Write your prediction and a reason before you run anything.

2. Observe

Read each value in the lab and write it in the table.

QuantityWhere to read itAB
Requested voltage at t = 2 s (V)Readout at 2 s
Applied voltage at t = 2 s (V)Readout at 2 s
Overshoot vs target (%)Measured response
Settling, ±2% of target (s)Measured response
Final error (rad/s)Measured response

3. Explain

  1. At t = 2 s, compare the requested and applied voltage in both runs. Where does run B's huge request come from?

  2. Run B ends the recording above the target. Why does the motor keep receiving full voltage after the speed passes the target?

Extension (optional)

Lower the target to 100 rad/s, where the motor needs less of its 12 V, and compare anti-windup off (run C) and on (run D). Does windup still matter?

Source: eigenroom.com/worksheets/motor/windupCite: EIGENROOM. (2026). When the actuator runs out [Lab worksheet]. Accessed YYYY-MM-DD. https://eigenroom.com/worksheets/motor/windup