EIGENROOMLAB WORKSHEET 33State feedback & observer

Fast estimates and noisy force

NameSectionDate

Goal

Measure how observer speed passes position noise into the estimated velocity and the applied force.

Setup

Open it on a phone or a computer; there is nothing to log in to or install. The link loads run A's settings:

Controller ωn
2 rad/s
Controller damping ζ
0.7
Observer speed ratio
1
Feedback state
Observer estimate
Target position
0.2 m
Initial position
0 m
Initial estimate error
0 m
Position noise amplitude
0.01 m
Force limit
10 N
  1. APreset, exactly as the link opens it.
  2. BChange only: Observer speed ratio → 5.

Pin each run before you change a setting, so you can compare runs at the same replay time.

1. Predict

If the observer trusts each noisy position reading more strongly, what happens to the control effort?

Write your prediction and a reason before you run anything.

2. Observe

Read each value in the lab and write it in the table.

QuantityWhere to read itAB
Applied force spread, 4–12 s (max − min) (N)Plot, with the replay cursor
Peak |estimated velocity|, 4–12 s (m/s)Plot, with the replay cursor
Final target error (m)Results below the plots

3. Explain

  1. Compare the spread of the applied force after the startup transient.

  2. If a faster observer shakes the force, why not always use a slow one?

Extension (optional)

Double the noise amplitude to 0.02 m with the faster observer (run C). How does the force spread scale?

Source: eigenroom.com/worksheets/state-feedback/observer-noiseCite: EIGENROOM. (2026). Fast estimates and noisy force [Lab worksheet]. Accessed YYYY-MM-DD. https://eigenroom.com/worksheets/state-feedback/observer-noise