EIGENROOMLAB WORKSHEET 26ANSWER KEY · FOR INSTRUCTORSMass–spring–damper

Drive near resonance

Goal

Measure the steady amplitude of a forced mass–spring–damper below, near and above resonance.

Setup

Open it on a phone or a computer; there is nothing to log in to or install. The link loads run A's settings:

Mass m
1 kg
Stiffness k
16 N/m
Damping c
1.6 N·s/m
Input type
Sine force
Force / amplitude
1 N
Angular frequency
1 rad/s
Initial displacement
0 m
Initial velocity
0 m/s
Duration
20 s
  1. APreset, exactly as the link opens it.
  2. BChange only: Angular frequency → 3.84 rad/s.
  3. CChange only: Angular frequency → 8 rad/s.
  4. DChange only: Damping c → 0 N·s/m, Angular frequency → 4 rad/s. (ext.)

1. Predict

A 1 N sine force moves this mass. Does a faster input always produce more displacement?

What happens

Here ωn = 4 rad/s and ζ = 0.2. The displacement gain peaks near ωr = 3.84 rad/s, below ωn. The frequency curve assumes a sinusoidal steady state, not the short-run peak. At zero damping and exact natural frequency, amplitude grows with time and no bounded sinusoidal steady state exists.

2. Observe

QuantityWhere to read itABCD ext.
Sinusoidal particular-response amplitude (m)Settings panel0.066 m0.159 m0.020 mNo bounded steady state
Largest |x|, 15–20 s (m)Plot, with the replay cursor0.066 m0.159 m0.020 m2.454 m
Peak absolute displacement (m)Prediction check measures0.069 m0.159 m0.042 m2.454 m

Values computed by Mass–spring–damper engine 1.0.0 at the settings above. A replay readout can differ in the last digit if the slider is not exactly at the stated time; values read from a plot are approximate.

3. Explain

  1. Does a faster input always produce more displacement?

    No. The steady amplitude is 0.066 m in run A, 0.159 m in run B and 0.020 m in run C. The displacement gain peaks near ωr = 3.837 rad/s, just below ωn, and falls above it.

  2. In run C the largest displacement over the whole recording is larger than the steady amplitude. Where does the extra motion come from?

    From the startup transient: switching on the sine force excites the free oscillation, which decays over the first seconds. The overall peak is 0.042 m, while the last 5 s show 0.020 m, matching the steady amplitude 0.020 m.

Extension (optional)

Set c = 0 and drive at 4 rad/s. What does the settings panel report, and what does the trace do?

The panel reports “No bounded steady state”: at zero damping and the natural frequency the amplitude grows without bound. The largest displacement in the last 5 s is 2.454 m, against 0.589 m in the first 5 s.

Source: eigenroom.com/worksheets/mechanics/resonance/answersCite: EIGENROOM. (2026). Drive near resonance [Lab worksheet]. Accessed YYYY-MM-DD. https://eigenroom.com/worksheets/mechanics/resonance