EIGENROOMLAB WORKSHEET 21DC motor · Dead time and limits

Dead time limits speed

NameSectionDate

Goal

Answer the experiment's question with numbers read from the lab: This PI loop settles in under 2 s. How much input dead time can it take before it oscillates?

Setup

Open it on a phone or a computer; there is nothing to log in to or install. The link loads run A's settings:

Target speed
50 rad/s
Loop
Closed loop
Controller type
PID
Proportional Kp
0.22
Integral Ki
0.6
Derivative Kd
0
Anti-windup
On
Load torque
0 N·m
Sensor noise
0
Controller period
20 ms
Disturbance events
None
Recording
12 s
  1. APreset, exactly as the link opens it.
  2. BColumn B: write down the one setting you changed.

Pin each run before you change a setting, so you can compare runs at the same replay time.

1. Predict

This PI loop settles in under 2 s. How much input dead time can it take before it oscillates?

Write your prediction and a reason before you run anything.

2. Observe

Read each value in the lab and write it in the table.

QuantityWhere to read itAB your change
Rise time, 10–90% of target (s)Measured response
Overshoot vs target (%)Measured response
Settling, ±2% of target (s)Measured response
Final error (rad/s)Measured response
Control effort (V·s)Measured response

3. Explain

  1. Follow the lab's instruction: “Pin this run, then raise Input dead time step by step: 50, 100, 200, 300 ms.” Record your changed run in column B. Which quantity changed the most, and in which direction?

  2. Explain the change you measured. What you were asked to watch: “Keep the gains. Raise Input dead time to 50, 100, 200 and 300 ms and compare overshoot, settling and the phase margin in the frequency workbench.”

Extension (optional)

Repeat the change with two more values of the same setting and sketch the measured quantity against the setting. Is the relationship linear?

Source: eigenroom.com/worksheets/motor/dead-timeCite: EIGENROOM. (2026). Dead time limits speed [Lab worksheet]. Accessed YYYY-MM-DD. https://eigenroom.com/worksheets/motor/dead-time