EXPERIMENT 21 / MOTOR LAB

This PI loop settles in under 2 s. How much input dead time can it take before it oscillates? Predict first ↓

TRYPin this run, then raise Input dead time step by step: 50, 100, 200, 300 ms.

REPLAYABLE SIMULATIONCALCULATING… / M-01
SPEED—TARGET50 rad/s
t = 0.00 s / 12.00 s
OSCILLOSCOPE / MEASURED RESPONSE

Step response

Loading plot…

Click the chart or move the time slider to replay.

TARGET50 rad/s
Actual—
Requested—
Applied—
Error now—
PINNED RUNS 0/3

Pin a run, change one setting, then compare the traces.

Rise, 10–90% of target—
Overshoot vs target—
Settling, ±2% of target—
Final error—
Control effort—

All three use the target speed as the reference, not the final speed. Rise: first 10% to first 90% of the target. Overshoot: peak speed above the target, as a percentage of the target, so a run that stops short of the target shows 0%. Settling: first recorded time after which the speed stays within ±2% of the target until the end, including any load events; “Not settled” if it is outside the band at the end. Defined for a positive target only.

01 / PREDICT

This PI loop settles in under 2 s. How much input dead time can it take before it oscillates?

What do you predict?
02 / CHECK YOUR PREDICTION

Did the result match your prediction?

Open to record a baseline

Choose a measurable prediction before changing a setting. Record the current result, change one condition, then check. This compares complete recordings, not the replay cursor.

Waiting for a complete, valid result. A stopped run or unavailable metric cannot be judged; choose another measure if needed.

Prediction and baseline stay in memory for this page only. Use Start a new prediction to choose a new baseline.
Frequency workbenchExplore the small-signal motor speed loop behind this controller setting.
FIELD NOTE / 21

Dead time limits speed

Read field notes

Termsdead time (time delay)phase marginovershoot

YOUR PREDICTION

Choose a prediction above before comparing the result.

WHAT TO WATCH

Keep the gains. Raise Input dead time to 50, 100, 200 and 300 ms and compare overshoot, settling and the phase margin in the frequency workbench.

Pin this run, then raise Input dead time step by step: 50, 100, 200, 300 ms.

CURRENT SETTINGS / LIVE SIGNAL
P 0.22 —I 0.6 —D 0 —

The large number is the gain; the smaller number is that term’s output at the replay cursor. Change one gain, then pin and compare the run.

Next experiment 22Tuning against dead time