EIGENROOMLAB WORKSHEET 22DC motor · Dead time and limits

Tuning against dead time

NameSectionDate

Goal

Answer the experiment's question with numbers read from the lab: On a motor with 200 ms of dead time, will the Ziegler–Nichols PI gains or half of them settle sooner?

Setup

Open it on a phone or a computer; there is nothing to log in to or install. The link loads run A's settings:

Target speed
30 rad/s
Loop
Closed loop
Controller type
PID
Proportional Kp
0.335
Integral Ki
0.41
Derivative Kd
0
Anti-windup
On
Load torque
0 N·m
Sensor noise
0
Controller period
20 ms
Disturbance events
None
Recording
12 s
  1. APreset, exactly as the link opens it.
  2. BColumn B: write down the one setting you changed.

Pin each run before you change a setting, so you can compare runs at the same replay time.

1. Predict

On a motor with 200 ms of dead time, will the Ziegler–Nichols PI gains or half of them settle sooner?

Write your prediction and a reason before you run anything.

2. Observe

Read each value in the lab and write it in the table.

QuantityWhere to read itAB your change
Rise time, 10–90% of target (s)Measured response
Overshoot vs target (%)Measured response
Settling, ±2% of target (s)Measured response
Final error (rad/s)Measured response
Control effort (V·s)Measured response

3. Explain

  1. Follow the lab's instruction: “Pin the Z–N run, then set P to 0.17 and I to 0.21, about half of each.” Record your changed run in column B. Which quantity changed the most, and in which direction?

  2. Explain the change you measured. What you were asked to watch: “The preset is the Z–N PI suggestion from the reaction curve, Kp 0.336 and Ki 0.412, rounded to the sliders as 0.335 and 0.41. Compare overshoot, rise and settling with the halved gains, and the phase margin in the frequency workbench.”

Extension (optional)

Repeat the change with two more values of the same setting and sketch the measured quantity against the setting. Is the relationship linear?

Source: eigenroom.com/worksheets/motor/detune-for-delayCite: EIGENROOM. (2026). Tuning against dead time [Lab worksheet]. Accessed YYYY-MM-DD. https://eigenroom.com/worksheets/motor/detune-for-delay