EXPERIMENT 22 / MOTOR LAB

On a motor with 200 ms of dead time, will the Ziegler–Nichols PI gains or half of them settle sooner? Predict first ↓

TRYPin the Z–N run, then set P to 0.17 and I to 0.21, about half of each.

REPLAYABLE SIMULATIONCALCULATING… / M-01
SPEED—TARGET30 rad/s
t = 0.00 s / 12.00 s
OSCILLOSCOPE / MEASURED RESPONSE

Step response

Loading plot…

Click the chart or move the time slider to replay.

TARGET30 rad/s
Actual—
Requested—
Applied—
Error now—
PINNED RUNS 0/3

Pin a run, change one setting, then compare the traces.

Rise, 10–90% of target—
Overshoot vs target—
Settling, ±2% of target—
Final error—
Control effort—

All three use the target speed as the reference, not the final speed. Rise: first 10% to first 90% of the target. Overshoot: peak speed above the target, as a percentage of the target, so a run that stops short of the target shows 0%. Settling: first recorded time after which the speed stays within ±2% of the target until the end, including any load events; “Not settled” if it is outside the band at the end. Defined for a positive target only.

01 / PREDICT

On a motor with 200 ms of dead time, will the Ziegler–Nichols PI gains or half of them settle sooner?

What do you predict?
02 / CHECK YOUR PREDICTION

Did the result match your prediction?

Open to record a baseline

Choose a measurable prediction before changing a setting. Record the current result, change one condition, then check. This compares complete recordings, not the replay cursor.

Waiting for a complete, valid result. A stopped run or unavailable metric cannot be judged; choose another measure if needed.

Prediction and baseline stay in memory for this page only. Use Start a new prediction to choose a new baseline.
Frequency workbenchExplore the small-signal motor speed loop behind this controller setting.
FIELD NOTE / 22

Tuning against dead time

Read field notes

TermsZiegler–Nichols tuningdead time (time delay)phase marginPID tuning

YOUR PREDICTION

Choose a prediction above before comparing the result.

WHAT TO WATCH

The preset is the Z–N PI suggestion from the reaction curve, Kp 0.336 and Ki 0.412, rounded to the sliders as 0.335 and 0.41. Compare overshoot, rise and settling with the halved gains, and the phase margin in the frequency workbench.

Pin the Z–N run, then set P to 0.17 and I to 0.21, about half of each.

CURRENT SETTINGS / LIVE SIGNAL
P 0.335 —I 0.41 —D 0 —

The large number is the gain; the smaller number is that term’s output at the replay cursor. Change one gain, then pin and compare the run.

Next experiment 23The wrong-way start
PProportional0.335