EIGENROOMLAB WORKSHEET 07DC motor · PID tuning

Push back against a load

NameSectionDate

Goal

Measure how far a short load pulse pushes the speed and how the feedback voltage answers it.

Setup

Open it on a phone or a computer; there is nothing to log in to or install. The link loads run A's settings:

Target speed
120 rad/s
Loop
Closed loop
Controller type
PID
Proportional Kp
0.22
Integral Ki
0.6
Derivative Kd
0.008
Anti-windup
On
Load torque
0.04 N·m
Sensor noise
0
Controller period
20 ms
Disturbance events
None
Recording
12 s
  1. APreset, exactly as the link opens it.
  2. BChange only: Disturbance events → Tap load 0.06 N·m at 4 s for 0.25 s. Replay to 4 s and press Tap load, then check that the event list matches this run's settings.

Pin each run before you change a setting, so you can compare runs at the same replay time.

1. Predict

How does the loop recover when the shaft load increases?

Write your prediction and a reason before you run anything.

2. Observe

Read each value in the lab and write it in the table.

QuantityWhere to read itAB
Lowest speed, 4–6 s (rad/s)Plot, with the replay cursor
Highest applied voltage, 4–6 s (V)Control effort plot
Settling, ±2% of target (s)Measured response
Final error (rad/s)Measured response

3. Explain

  1. How far does the speed fall during the tap, and what does the applied voltage do?

  2. The target is the same in both runs. Why does the settling time change?

Extension (optional)

Replace the tap with a Step load of the same size at 4 s (run C). Does the speed return to the target?

Source: eigenroom.com/worksheets/motor/disturbanceCite: EIGENROOM. (2026). Push back against a load [Lab worksheet]. Accessed YYYY-MM-DD. https://eigenroom.com/worksheets/motor/disturbance