EIGENROOMLAB WORKSHEET 08DC motor · Lead and lag

Shape phase with lead

NameSectionDate

Goal

Relate a lead compensator's zero and pole to phase margin, speed and steady error.

Setup

Open it on a phone or a computer; there is nothing to log in to or install. The link loads run A's settings:

Target speed
120 rad/s
Loop
Closed loop
Controller type
Lead compensator
Controller gain
2
Zero frequency
4 rad/s
Pole frequency
8 rad/s
Load torque
0.04 N·m
Sensor noise
0
Controller period
20 ms
Disturbance events
None
Recording
12 s
  1. APreset, exactly as the link opens it.
  2. BChange only: Zero frequency → 6 rad/s.

Pin each run before you change a setting, so you can compare runs at the same replay time.

1. Predict

Can a zero before a pole quicken the response without an integrator?

Write your prediction and a reason before you run anything.

2. Observe

Read each value in the lab and write it in the table.

QuantityWhere to read itAB
Phase margin (°)Frequency workbench
Gain margin (dB)Frequency workbench
Rise time, 10–90% of target (s)Measured response
Final error (rad/s)Measured response

3. Explain

  1. Moving the zero toward the pole shrinks the phase lead. What happens to the phase margin and to the rise time?

  2. Neither run settles inside ±2% of the target. Why can't a lead compensator remove the steady error on its own?

Extension (optional)

Move the zero to 2 rad/s instead. Predict the phase margin and the final error before you look.

Source: eigenroom.com/worksheets/motor/leadCite: EIGENROOM. (2026). Shape phase with lead [Lab worksheet]. Accessed YYYY-MM-DD. https://eigenroom.com/worksheets/motor/lead