EIGENROOMLAB WORKSHEET 39ANSWER KEY · FOR INSTRUCTORSRLC circuit

Choose which resonance you mean

Goal

Measure which drive frequency maximizes the capacitor voltage, and see that the current peaks elsewhere.

Setup

Open it on a phone or a computer; there is nothing to log in to or install. The link loads run A's settings:

Inductance L
1 H
Capacitance C
0.0625 F
Resistance R
1 Ω
Source waveform
Sine voltage
Source / amplitude
1 V
Angular frequency
1 rad/s
Initial capacitor voltage
0 V
Initial current
0 A
  1. APreset, exactly as the link opens it.
  2. BChange only: Angular frequency → 3.94 rad/s.
  3. CChange only: Angular frequency → 8 rad/s.
  4. DChange only: Angular frequency → 4 rad/s. (ext.)

1. Predict

Must the largest capacitor-voltage response occur exactly at ωn = 1/√(LC)?

What happens

With L = 1, C = 0.0625 and R = 1, ωn = 4 rad/s and ζ = 0.125. The capacitor-voltage gain peaks near 3.94 rad/s; series-current magnitude peaks at 4 rad/s. The measured quantity matters. At zero resistance and exact natural frequency, a nonzero sine has no bounded sinusoidal steady state.

2. Observe

QuantityWhere to read itABCD ext.
Peak |capacitor voltage|, 8–12 s (V)Plot, with the replay cursor1.064 V4.018 V0.3373 V3.99 V
Peak |circuit current|, 8–12 s (A)Plot, with the replay cursor0.06709 A0.9892 A0.1666 A0.9963 A
Peak |capacitor voltage| (V)Plot, with the replay cursor1.148 V4.018 V0.735 V3.99 V

Values computed by State-feedback, tank and RLC engine 1.0.0 at the settings above. A replay readout can differ in the last digit if the slider is not exactly at the stated time; values read from a plot are approximate.

3. Explain

  1. Which drive frequency gives the largest capacitor voltage late in the run, and how large is it compared with the source amplitude?

    Run B: 4.018 V, against 1.064 V in run A and 0.3373 V in run C, for a source amplitude of 1 V. With ζ = 0.125, the voltage gain near resonance is close to 1/(2ζ).

  2. Compare the late current amplitudes. Is the current largest at the same frequency as the capacitor voltage?

    Not exactly. The capacitor voltage peaks near ωn√(1 − 2ζ²) = 3.937 rad/s, while the series current peaks at ωn = 4 rad/s, where the inductor and capacitor reactances cancel. Run B's current is 0.9892 A; the extension compares it with a drive at ωn itself.

Extension (optional)

Drive at exactly ωn, 4 rad/s (run D). Compare the late capacitor voltage and current with run B.

The capacitor voltage is 3.99 V, slightly below run B's 4.018 V, while the current 0.9963 A is slightly above run B's 0.9892 A. Which resonance you mean depends on what you measure.

Source: eigenroom.com/worksheets/rlc/rlc-resonance/answersCite: EIGENROOM. (2026). Choose which resonance you mean [Lab worksheet]. Accessed YYYY-MM-DD. https://eigenroom.com/worksheets/rlc/rlc-resonance