EIGENROOMLAB WORKSHEET 37RLC circuit

One voltage, different ringing

NameSectionDate

Goal

Separate what sets an RLC circuit's final capacitor voltage from what sets its ringing.

Setup

Open it on a phone or a computer; there is nothing to log in to or install. The link loads run A's settings:

Inductance L
1 H
Capacitance C
0.0625 F
Resistance R
1 Ω
Source waveform
Voltage step
Source / amplitude
5 V
Angular frequency
4 rad/s
Initial capacitor voltage
0 V
Initial current
0 A
  1. APreset, exactly as the link opens it.
  2. BChange only: Resistance R → 8 Ω.
  3. CChange only: Resistance R → 10 Ω.

Pin each run before you change a setting, so you can compare runs at the same replay time.

1. Predict

Does adding resistance change the final capacitor voltage or the way it gets there?

Write your prediction and a reason before you run anything.

2. Observe

Read each value in the lab and write it in the table.

QuantityWhere to read itABC
Damping ratio ζSettings panel
Peak |capacitor voltage| (V)Plot, with the replay cursor
Capacitor voltage at t = 1 s (V)Readout at 1 s
Capacitor voltage at t = 12 s (V)Readout at 12 s

3. Explain

  1. Did the resistance change the final capacitor voltage?

  2. Why does run A rise far above the source voltage?

  3. Runs B and C have no overshoot. Which reaches the source voltage sooner?

Extension (optional)

Set R = 0 (run D). What does the capacitor voltage do?

Source: eigenroom.com/worksheets/rlc/rlc-stepCite: EIGENROOM. (2026). One voltage, different ringing [Lab worksheet]. Accessed YYYY-MM-DD. https://eigenroom.com/worksheets/rlc/rlc-step