EIGENROOMLAB WORKSHEET 37ANSWER KEY · FOR INSTRUCTORSRLC circuit

One voltage, different ringing

Goal

Separate what sets an RLC circuit's final capacitor voltage from what sets its ringing.

Setup

Open it on a phone or a computer; there is nothing to log in to or install. The link loads run A's settings:

Inductance L
1 H
Capacitance C
0.0625 F
Resistance R
1 Ω
Source waveform
Voltage step
Source / amplitude
5 V
Angular frequency
4 rad/s
Initial capacitor voltage
0 V
Initial current
0 A
  1. APreset, exactly as the link opens it.
  2. BChange only: Resistance R → 8 Ω.
  3. CChange only: Resistance R → 10 Ω.
  4. DChange only: Resistance R → 0 Ω. (ext.)

1. Predict

Does adding resistance change the final capacitor voltage or the way it gets there?

What happens

For this ideal series circuit, LC vC″ + RC vC′ + vC = vin. Positive resistance dissipates energy and the capacitor approaches the constant source voltage. R changes damping, not that DC gain. At R = 0, a step can ring forever; the existence of a DC equilibrium does not imply convergence.

2. Observe

QuantityWhere to read itABCD ext.
Damping ratio ζSettings panel0.12511.250
Peak |capacitor voltage| (V)Plot, with the replay cursor8.364 V5 V5 V10 V
Capacitor voltage at t = 1 s (V)Readout at 1 s7.3345 V4.5421 V4.0983 V8.2682 V
Capacitor voltage at t = 12 s (V)Readout at 12 s5.0116 V5 V5 V8.2007 V

Values computed by State-feedback, tank and RLC engine 1.0.0 at the settings above. A replay readout can differ in the last digit if the slider is not exactly at the stated time; values read from a plot are approximate.

3. Explain

  1. Did the resistance change the final capacitor voltage?

    No: all three runs end near the source voltage of 5 V (5.0116 V, 5 V and 5 V at 12 s). At DC the capacitor carries no current, so nothing drops across R; R only sets the damping.

  2. Why does run A rise far above the source voltage?

    With ζ = 0.125 the circuit is underdamped: the inductor keeps current flowing after the capacitor reaches the source voltage, charging it up to 8.364 V. At critical damping (run B, ζ = 1) the peak is 5 V.

  3. Runs B and C have no overshoot. Which reaches the source voltage sooner?

    Run B: at 1 s it is at 4.5421 V, against 4.0983 V for the overdamped run C.

Extension (optional)

Set R = 0 (run D). What does the capacitor voltage do?

It rings without decay between zero and twice the source voltage: the peak is 10 V, and at 12 s it is still at 8.2007 V. A DC equilibrium exists but is never reached.

Source: eigenroom.com/worksheets/rlc/rlc-step/answersCite: EIGENROOM. (2026). One voltage, different ringing [Lab worksheet]. Accessed YYYY-MM-DD. https://eigenroom.com/worksheets/rlc/rlc-step