EIGENROOMLAB WORKSHEET 32State feedback & observer

Recover a hidden velocity

NameSectionDate

Goal

Measure how quickly a Luenberger observer corrects a wrong initial estimate, and what a faster observer costs.

Setup

Open it on a phone or a computer; there is nothing to log in to or install. The link loads run A's settings:

Controller ωn
2 rad/s
Controller damping ζ
0.7
Observer speed ratio
1
Feedback state
Observer estimate
Target position
0.2 m
Initial position
0 m
Initial estimate error
0.3 m
Position noise amplitude
0 m
Force limit
10 N
  1. APreset, exactly as the link opens it.
  2. BChange only: Observer speed ratio → 3.
  3. CChange only: Feedback state → True state.

Pin each run before you change a setting, so you can compare runs at the same replay time.

1. Predict

Only position is measured. Can the observer correct an initially wrong position estimate and infer velocity?

Write your prediction and a reason before you run anything.

2. Observe

Read each value in the lab and write it in the table.

QuantityWhere to read itABC
Position estimation error at t = 0.2 s (m)Readout at 0.2 s
Position estimation error at t = 0.5 s (m)Readout at 0.5 s
Peak |estimated velocity|, 0–1 s (m/s)Plot, with the replay cursor
Peak |applied force|, 0–1 s (N)Plot, with the replay cursor
Position at t = 1 s (m)Readout at 1 s

3. Explain

  1. How much faster does the estimation error shrink in run B?

  2. What does the faster observer cost?

  3. Run C feeds back the true state. Why is its estimation error the same as run A's?

Extension (optional)

Set the initial estimate error to 0 with run A's other settings (run D). Does observer feedback still differ from true-state feedback?

Source: eigenroom.com/worksheets/state-feedback/observer-recoveryCite: EIGENROOM. (2026). Recover a hidden velocity [Lab worksheet]. Accessed YYYY-MM-DD. https://eigenroom.com/worksheets/state-feedback/observer-recovery