EIGENROOMLAB WORKSHEET 31State feedback & observer

Move the closed-loop poles

NameSectionDate

Goal

Place the closed-loop poles of a mass–spring–damper and measure the force a faster design asks for.

Setup

Open it on a phone or a computer; there is nothing to log in to or install. The link loads run A's settings:

Controller ωn
2 rad/s
Controller damping ζ
0.7
Observer speed ratio
2
Feedback state
True state
Target position
0.2 m
Initial position
0 m
Initial estimate error
0.3 m
Position noise amplitude
0 m
Force limit
10 N
  1. APreset, exactly as the link opens it.
  2. BChange only: Controller ωn → 4 rad/s.
  3. CChange only: Controller ωn → 6 rad/s.

Pin each run before you change a setting, so you can compare runs at the same replay time.

1. Predict

Does doubling the desired natural frequency improve speed without any cost?

Write your prediction and a reason before you run anything.

2. Observe

Read each value in the lab and write it in the table.

QuantityWhere to read itABC
Requested force at t = 0 s (N)Readout at 0 s
Position at t = 0.5 s (m)Readout at 0.5 s
Position at t = 1 s (m)Readout at 1 s
Clipped command time (s)Results below the plots

3. Explain

  1. How does the force requested at t = 0 s grow with ωn, and why?

  2. None of these runs reaches the force limit. What happens to the pole-placement design once the request exceeds it?

Extension (optional)

Keep ωn = 6 rad/s and raise the target position to 0.5 m (run D). How long is the command clipped?

Source: eigenroom.com/worksheets/state-feedback/place-polesCite: EIGENROOM. (2026). Move the closed-loop poles [Lab worksheet]. Accessed YYYY-MM-DD. https://eigenroom.com/worksheets/state-feedback/place-poles